WEC8500/WEC8050 (APC) Operation Manual v10.1 430
©Samsung Electronics America
FTP/sFTP
The FTP is a network service for file transmission. The APC support the client and server
function for FTP and sFTP (Secure FTP).
Configuration using CLI
[SFTP Server Configuration]
The secure FTP server configuration is as follows:
1 Go to the configure mode of the CLI.
WEC8500# configure terminal
2 Enable or disable the sFTP server.
o sftp-server enable: Enable
o no sftp-server enable: Disable
3 Enter as follows to change a user’s ID and password.
o sftp-server chguser [ID] [PASSWORD]
User password of a server (alphabet/special
letters/number combination, more than 8 characters)
4 To check the status of sFTP server, enter the ‘show sftp-server’
command.
[FTP Server Configuration]
1 Go to the configure mode of the CLI.
WEC8500# configure terminal
2 Enable or disable the sFTP server.
o ftp-server enable: Enable
o no ftp-server enable: Disable
3 Enter as follows to change a user’s ID and password.
o ftp-server chguser [ID] [PASSWORD]
User password of a server (alphabet/special
letters/number combination, more than 8 characters)
4 To change the idle timeout, enter the command below. The unit of
timeout is minutes and the default value is 15 minutes.
o ftp-server idle-timeout [timeout]
To Next Page
