WEC8500/WEC8050 (APC) Operation Manual v10.1 414
©Samsung Electronics America
Figure 289. Remote AP Group-ACL Profile Configuration
Configuration Synchronization (Remote AP Group)
The W-EP WLAN system provides a function of synchronizing the configuration of the AP
of the remote group and ACL if the AP of the remote group operates as a local bridge.
Requesting Synchronization
If the remote AP operates with the local switching mode, the configuration of the ACL
between APC and AP must be synchronized. If AP and CAPWAP run, the configuration of
the ACL is automatically synchronized, but if the operator changes the ACL of the APC,
the synchronization of ACL configuration must be performed as follows:
Configuration using CLI
The synchronization of the AP of the remote group uses the following CLI:
WEC8500# configure terminal
WEC8500/configure# rbac
WEC8500/configure/rbac# sync-config ?
acl-profile Sync-config Acl profile
all Sync-config All
ap Sync-config Remote Ap Group
remote-ap-group Sync-config Remote Ap Group
• all: Perform synchronization for all APs of the remote group.
• remote-ap-group [group-name]: Performs synchronization only for the
APs included in the corresponding remote group.
• acl-profile [profile-name]: Performs synchronization only for the APs
included in the remote group which uses the corresponding ACL profile
(CLI only).
To Next Page
Loading...
