Samsung WEC8050 - Configuring Web Pass-Through

WEC8500/WEC8050 (APC) Operation Manual v10.1 385
©Samsung Electronics America
Configuring Web Pass-through
The APC provides the web pass-through function to move to a specific address all the
time when the user uses the web.
Configuration using CLI
[WLAN Configuration]
To configure web pass-through in the WLAN, execute the command as follows:
1 Go to configure  WLAN configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wlan 1
2 Go to configure  WLAN  security  layer 3 configuration mode of
CLI.
WEC8500/configure/wlan 1# security
WEC8500/configure/wlan 1/security# layer3
WEC8500/configure/wlan 1/security/layer3#
3 Enable the WEB authentication (default: disabled).
o web-policy pass-through
WEC8500/configure/wlan 1/security/layer3# web-policy pass-through
4 Configure the Pre-Authentication ACL.
o pre-auth-acl [ACL]
Parameter
Description
ACL
ACL for occurrence of redirection
5 Configure the Web Page Type.
o web-page-type [Page Type]
Parameter
Description
Page Type
Web authentication method
• external: Uses the authentication page of an external web
server.
• downloaded: Uses the authentication page downloaded from the
system.
6 The configuration can be checked using the ‘show wlan security detail’
command.
WEC8500# show wlan security detail 1
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<WLANs> menu in the sub-menus. In the WLANs screen, select WLAN ID, move to