WEC8500/WEC8050 (APC) Operation Manual v10.1 191
©Samsung Electronics America
File transmission protocol (ftp/sftp)
• ftp: ftp is used for file transmission.
• sftp: sftp is used for file transmission.
[max-download]
This command configures the maximum number of simultaneous downloads when
transmitting the package file of an AP from the APC to the AP.
• Max-download [COUNT]
Maximum number of simultaneous downloads of AP image
file (range: 1-50, default: 10)
[max-retry]
This command configures maximum number of re-attempts when AP upgrade is failed.
• Max-retry [COUNT]
Maximum number of AP upgrade re-attempts (range: 1-10,
default: 3)
[start]
This command provides the entire AP upgrade function.
• start [UPGRADE_TYPE]
Configures upgrade type (quick-upgrade/predownload)
• quick-upgrade: Perform entire ap upgrade upon an
operator’s request.
• predownload: Download ap image to ap first during entire ap
upgrade.
If you perform package upgrade after configuring AP upgrade type to predownload,
restart all the APs in the following methods:
WEC8500# configure terminal
WEC8500/configure# ap-all
WEC8500/configure/ap-all# reboot upgrade
[stop]
This command provides the function of stopping the image upgrade of all the APs.
• stop
[show ap upgrade]
To check the upgrade information of an AP, use the following command:
To Next Page
