Samsung WEC8050 - Page 231

WEC8500/WEC8050 (APC) Operation Manual v10.1 212
©Samsung Electronics America
WEC8500# configure terminal
WEC8500/configure# wlan 1
WEC8500/configure/wlan 1
2 Enter to 80211a or 80211b per the band to be set.
WEC8500/configure/wlan 1# 80211a
WEC8500/configure/wlan 1/80211a#
3 Configure the data rate. Each configuration described below can be set
if the corresponding wlan is disabled.
WEC8500/configure/wlan 1/80211a# rate [MODE][RATE]
Parameter
Description
MODE
Mode (basic/supported)
• basic: Basic rate supported for a terminal to access to
an AP.
• supported: A connected terminal that supports the
supported rate can communicate with an AP at the
supported rate.
RATE
Data rate
• Range for 80211a: 6, 9, 12, 18, 24, 36, 48, or 54 Mbps
• Range for 80211b: 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48,
or 54 Mbps
4 Configure 802.11n MCS(Modulation and Coding Scheme) rate.
WEC8500/configure/wlan 1/80211a# mcs-11n [RATE]
Parameter
Description
RATE
MSC rate (range: 0-31)
5 Configure the 802.11ac MCS (Modulation and Coding Scheme) rate.
802.11ac MCS can configure only 5G band.
WEC8500/configure/wlan 1/80211a# mcs-11ac num-ss 2~4
enter the maximum MCS(7~9) for 1 spatial stream(s): 7
the maximum MCS : 7
enter the maximum MCS(7~9) for 2 spatial stream(s): 7
the maximum MCS : 7
enter the maximum MCS(7~9) for 3 spatial stream(s): 7
the maximum MCS : 7
enter the maximum MCS(7~9) for 4 spatial stream(s): 7
the maximum MCS : 7
[Wlan:1] Radio : 5GHz, number of SS: 4, max mcs : 7, 7, 7, 7 Enable
6 Configuration status can be confirmed through “show wlan detail #”
command.