Samsung WEC8050 - Page 233

WEC8500/WEC8050 (APC) Operation Manual v10.1 214
©Samsung Electronics America
Configuration using CLI
1 Go to configure  wlan configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wlan 1
WEC8500/configure/wlan 1
2 Configure iot-enablement Enable/Disable.
WEC8500/configure/wlan 1# iot-enablement
WEC8500/configure/wlan 1# no iot-enablement
3 Configure iot-device-type.
WEC8500/configure/wlan 1# iot-device-type [DEVICE_TYPE]
Parameter
Description
cctv
CCTV
4 Configure iot-discovery-mode.
WEC8500/configure/wlan 1# iot-discovery-mode [MODE]
Parameter
Description
auto
Automatic Selection Mode
static
Static Mode
5 Configure iot-protocol.
WEC8500/configure/wlan 1# iot-protocol [PROTOCOL]
Parameter
Description
udp
Use UDP as the IoT protocol.
tcp
Use TCP as the IoT protocol.
6 Configure the iot-protocol-port. (0 – 65535 )
WEC8500/configure/wlan 1# iot-protocol-port [RORT]
7 Select iot-uplink-priority Enable/Disable.
WEC8500/configure/wlan 1# iot-uplink-priority
WEC8500/configure/wlan 1# no iot-uplink-priority
Detailed uplink-priority can be configured in wlan-uplink-priority. This is