Samsung WEC8050 - Page 244

WEC8500/WEC8050 (APC) Operation Manual v10.1 225
©Samsung Electronics America
To configure WPA/WPA2 802.1x to WLAN, execute the command as follows:
As the 802.1x authentication needs interoperation with a RADIUS server,
the RADIUS server required for the WLAN security configuration must be
configured first. For more information about RADIUS server configuration,
see ‘8.1 RADIUS Server Configuration’.
For 802.1x authentication, user authentication can be implemented by
linking to the external LDAP Server (including Active Directory Server) via
embedded RADIUS server since package version 4.6.0. For detailed
information, refer to “Internal RADIUS Server” Section in Chapter 8.
Configuration using CLI
1 Go to configure  wlan configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# wlan 1
2 Go to security configuration mode and initialize the configuration.
WEC8500/configure/wlan 1# security
WEC8500/configure/wlan 1/security# setDefault
3 Configure the WPA type.
WEC8500/configure/wlan 1/security# wpa_type
Parameter
Description
wpa_type
WPA type (wpa/wpa2): WPA Version 2 must be enabled at
all times.
• wpa: WPA Version 1
• wpa2: WPA Version 2
4 Configure the encryption type.
WEC8500/configure/wlan 1/security# [WPA_TYPE] [ENC_TYPE]
Parameter
Description
WPA_TYPE
WPA type (wpa/wpa2): Use the same value as the WPA type
configured before. WPA Version 2 must be enabled at all
times.
• wpa: WPA Version 1
• wpa2: WPA Version 2
ENC_TYPE
Encryption type (tkip/ccmp)
• tkip: TKIP type. TKIP cannot be configured for WPA