WEC8500/WEC8050 (APC) Operation Manual v10.1 428
©Samsung Electronics America
is not configured.)
• ntp client server-addr hostname <WORD> version [1-4]: Enable
• no ntp client server-addr hostname <WORD> version [1-4]: Disable
[Configuring based on IP address]
Enable or disable.
• ntp client server-addr ip <A.B.C.D>: Enable
• no ntp client server-addr ip <A.B.C.D>: Disable
Configure the index of a server that a NTP client will refer to. (Use a default value 1 if it is
not configured.)
• ntp client server-addr ip <A.B.C.D> index [1-5]: Enable
• no ntp client server-addr ip <A.B.C.D> index [1-5]: Disable
Configure the version of a server that a NTP client will refer to. (Use a default value 1 if it
is not configured.)
• ntp client server-addr ip <A.B.C.D> version [1-4]
• no ntp client server-addr ip <A.B.C.D> version [1-4]
You can proceed with configurations simultaneously as shown below.
• ntp client server-addr hostname <WORD> index [1-5] version [1-4]
• ntp client server-addr hostname <WORD> version [1-4] index [1-5]
• ntp client server-addr ip <A.B.C.D> index [1-5] version [1-4]
• ntp client server-addr ip <A.B.C.D> version [1-4] index [1-5]
• no ntp client server-addr hostname <WORD> index [1-5] version [1-4]
• no ntp client server-addr hostname <WORD> version [1-4] index [1-5]
• no ntp client server-addr ip <A.B.C.D> index [1-5] version [1-4]
• no ntp client server-addr ip <A.B.C.D> version [1-4] index [1-5]
[NTP Server Configuration]
The NTP server configuration is as follows:
1 Go to the configure mode of the CLI.
WEC8500# configure terminal
2 Configure a NTP server.
o ntp server enable: Configures a NTP server.
o no ntp server enable: Disables a NTP server.
[Checking NTP Configuration Status]
To check the status of a NTP client or server, enter the ‘show ntp’ command.
To Next Page
