A2537-002/01 February 2020 2-5 SEMCO Proprietary Information
F. DISPLAY - Menu to select what is to be displayed on any of the 4 display screens. The far right screen
next to the keypad is the default display.
G. DATA RATE - Menu to enter the demodulator data rate for ALL (default) demods or CH1, CH2 and
Combiner individually. Data rate is entered in kbps, which then switches to Mbps when the data rate
value entered is 1000.0 kbps or greater.
H. COMB MODE - Menu to set any parameter of the Combiner
I. MENU - Main Menu showing receiver information (Name, ID channels, serial numbers etc) in addition
to Slaving mode, 10MHz Reference Int/Ext selection and TMoIP. The following example is provided
as to all menu settings:
Name: RC100
Type: RC100 (Dual Channel Receiver Combiner)
ID: Receiver Serial Number (e.g. 17010-0001)
Channels: 2R 1C 3D (2 receiver channels, 1 combiner channel and 3 demodulator channels)
Card List: 2R 1C 3D (2 receiver channels, 1 combiner channel and 3 demodulator channels)
Version: 1.06.0 (Software Version)
Slaving None (will show None, Diversity or Frequency depending on user selection)
The circular Menu Navigation and Entry buttons are described as follows:
The Navigation buttons and Numerical Entry buttons have a dual overlapping function. The keypad has
numerical buttons from 0 through 9, a DELETE button which serves as a backspace function and an
ENTER button to submit the entered/selected numerical value. Overlapping the keypad in blue colors are
the UP (2), DOWN (8), LEFT (4), and RIGHT (6) arrows, a SELECT (5) button and an EXIT (DELETE)
button.
To start navigation, first select a desired FUNCTION from one of the square buttons. The far-right display
next to the keypad will change to the function selected. In certain cases (TUNER, MOD MODE, DEMOD,
and COMB MODE), there is an option to change parameters for ALL, CH1, CH2 or Combiner. In certain
cases, there is also a < and > in the top title bar of the display, and the CH1, CH2 or Combiner selection
will be displayed (i.e. <Ch1>). To change this selection, use the LEFT (4) and RIGHT (6) arrows to move
between the selections and press ENTER when the desired setting is displayed.
For FREQ and DATA RATE functions, the display will show all selections highlighted in blue in the center
of the screen. To change the parameter for an individual channel, press the function button again. The
individual selection will be highlighted in blue while the other(s) will be deselected. Press the function again
to toggle to the other selection(s). After moving through the selections, the final function press will exit the
menu.
In the individual menus, there are many parameters in a list mode signified by a
∧
and
∨
above and below
the list. Use the UP (2) and DOWN (8) arrow to scroll up and down the menu, and the selected parameter
will be highlighted in bright blue. To change that parameter, press ENTER or SELECT (5), and the
parameter will be highlighted in a bright magenta color.
Once the desired parameter is selected, use the UP (2) and DOWN (8) arrow again to scroll though the
available selections for the selected parameter. Depending on the parameter, there may be from 2 to as
many as 15 available selections. For numerical values, enter the number using the keypad. In all cases
pressing ENTER will program the selected value to the receiver. Pressing the EXIT (DELETE) button will
also exit the current menu.
To Next Page
Loading...