A2537-002/01 February 2020 6-3 SEMCO Proprietary Information
Figure 6-4 depicts the Demodulator Control Window on the remote GUI. Clicking on the arrow icon to the
right of the Demod Mode box provides a pull-down menu for demodulator mode selection. The operator
uses the pull-down menu Up/Down arrows to scroll and click on the desired demodulator format
Figure 6-4
Demodulator Mode Selection on Remote GUI
6.3 Demodulator Data Rate Entry
Demodulator Data Rate selection using the front panel displays and controls is shown in Figure 6-5. The
operator selects DATA RATE on the keypad, and then uses the numerical keypad to enter the desired
data rate. The data rate will read in kbps and then switch to Mbps for data rate entry above 1.0 Mbps.
The operator pushes ENTER or Select (5) and the data rate of Ch1, Ch2 and Combiner demodulators
are changed.
Figure 6-5
Demodulator Data Rate Selection Using Front Panel Displays and Keypad
Referring to Figure 6-6, the data rate of individual channels can be changed using the same procedures
described above as follows:
A. Push DATA RATE button 2 times - Ch1
B. Push DATA RATE button 3 times - Ch2
C. Push DATA RATE button 4 times - Combiner
Pushing the DATA RATE button 5 times exits the menu.
To Next Page
Loading...