A2537-002/01 February 2020 SEMCO Proprietary Information
ILLUSTRATIONS (cont.)
FIGURE TITLE PAGE
2-18 Changing a Receiver IP Address 2-12
2-19 System Naming Feature 2-13
2-20 Slaving Feature on Remote GUI 2-14
2-21 Slaving Feature on Front Panel 2-14
2-22 System Card Set Selection on Remote GUI 2-15
2-23 AGC Strip Chart Display 2-15
2-24 AGC Data/System Parameters Logging 2-16
2-25 Combiner Zero Feature 2-16
2-26 Combiner Zero Feature on Front Panel/Keypad 2-17
2-27 TM over IP Feature 2-17
2-28 Eye Pattern and Constellation Feature 2-18
2-29 Eye Pattern and Constellation Selection Using Front Panel 2-18
2-30 Save Presets Feature 2-19
2-31 Load Presets Feature 2-20
2-32 Receiver Help Feature 2-20
3-1 RC100C-2 Rear Panel Telemetry I/O 3-1
4-1 RF Frequency Selection (Both CHs) Using Front Panel Displays
and Keypad 4-1
4-2 RF Frequency Selection (single CH) Using Front Panel Displays
and Keypad 4-1
4-3 RF Frequency Selection from the Tuner Menu 4-2
4-4 RF CIF Frequency Selection from the Tuner Menu 4-2
4-5 Remote GUI Frequency Selection 4-3
4-6 Frequency Up/Down Increment Selection on Remote GUI
4-3
4-7 Entering a CIF-Band Frequency on Remote GUI 4-4
4-8 Absolute RSSI Status Display 4-4
4-9 AGC Zero and Relative RSSI Status Settings 4-5
4-10 Antenna Signal Strength and Correction Factor Settings 4-6
4-11 Absolute and Relative Signal Strength Display on Remote GUI 4-7
4-12 Maximum/Average Signal Strength Indicator on Remote GUI 4-7
4-13 Antenna Signal Strength Feature on Remote GUI 4-8
4-14 Front Panel IF SAW Filter Bandwidth Selection 4-9
4-15 IF FIR Filter Bandwidth Selection 4-9
4-16 IF SAW Filter Bandwidth Selection on Remote GUI 4-10
4-17 IF FIR Filter Bandwidth Selection on Remote GUI 4-10
4-18 AM LPF Frequency, Polarity and Impedance Selection Using
Front Panel 4-11
4-19 AM LPF Frequency, Polarity and Impedance Selection Using
Remote GUI 4-12
4-20 AGC Slope and Polarity Selection Using Front Panel 4-13
4-21 AGC Impedance and Time Constant Selection Using Front Panel 4-14
4-22 AGC Zero Using Front Panel 4-15
4-23 AGC Freeze Using Front Panel 4-16
4-24 AGC Slope and Polarity on Remote GUI 4-16
4-25 AGC Output Impedance on Remote GUI 4-17
4-26 AGC Zero Feature on Remote GUI 4-17
To Next Page
Loading...