Semco RC100C-2 - Title Page

A2537-002/01 February 2020 SEMCO Proprietary Information
i
TABLE OF CONTENTS
SECTION TITLE PAGE
SECTION 1 INTRODUCTION 1-1
1.1 Scope 1-1
1.2 Purpose and Description 1-1
SECTION 2 GETTING STARTED 2-1
2.1 Receiver Description 2-1
2.2 Receiver Hardware Installation 2-2
2.2.1 SD Card Interface 2-2
2.3 Receiver Software 2-3
2.4 System Boot and Shutdown 2-4
2.4.1 Navigating the Front Panel LCD Displays and Keypad 2-4
2.4.2 Front Panel Display Screen Settings 2-6
2.4.2.1 Front Panel Display Screen Settings Example 2-6
2.4.3 STATUS Lock/Unlock Indicators 2-9
2.5 Initial SLTS Remote Network Setup 2-9
2.5.1 Changing a Receiver IP Address 2-11
2.5.2 System Naming Feature 2-12
2.6 SLTS Network GUI Design Features 2-13
2.6.1 Toolbar Features 2-13
2.6.1.1 Receiver Settings 2-13
2.6.1.2 System Configuration 2-13
2.6.1.3 Windows 2-15
SECTION 3 HARDWARE I/O 3-1
3.1 Hardware Telemetry I/O 3-1
3.1.1 Single Card Receiver (SCR) Hardware
3-2
3.1.2 Diversity Combiner Hardware 3-2
3.1.3 IF Demodulator Hardware 3-2
3.1.4 Optional Multi-Channel Bit Synchronizer, Frame Synchronizer,
BERT and PN Generator 3-3
3.1.5 TM over I/P Option 3-3
3.1.6 Additional RC100C-2 Hardware 3-3
SECTION 4 TELEMETRY RF RECEIVER OPERATION 4-1
4.1 RF Frequency Settings 4-1
4.1.1 RF Frequency Settings Using Front Panel Controls 4-1
4.1.1.1 Front Panel C/CIF-Band Frequency Settings 4-2
4.1.2 RF Frequency Settings Using the SLTS Program Remote GUI 4-3
4.2 Receiver Signal Strength Indicator (RSSI) 4-4
4.2.1 Front Panel Absolute RSSI Display 4-4
4.2.2 Front Panel Relative RSSI Display 4-4
4.2.3 Front Panel Antenna Signal Strength Display 4-5
4.2.4 Remote GUI RSSI Displays and Settings 4-7
4.3 IF Filter Bandwidth Selection and Control 4-8
4.3.1 Front Panel IF SAW Filter Selection 4-8
4.3.2 Front Panel IF FIR Filter Selection 4-9
4.3.3 Remote GUI IF SAW Filter Selection 4-10
4.3.4 Remote GUI IF FIR Filter Selection 4-10