EasyManua.ls Logo

Semco RC100C-2 - Page 2

Semco RC100C-2
105 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A2537-002/01 February 2020 SEMCO Proprietary Information
SAFETY SUMMARY
System Weight and Handling Restrictions - The RC100C-2 Spectrum Efficient Ground Receiver
(SEGR) weighs approximately 15 lbs. (23 kg). Take care in the lifting and installation of each chassis.
When lifting the chassis, always lift from the bottom of the main chassis frame.
Electrical The RC100C-2 SEGR is designed to operate on 115/230 VAC 50/60 Hz and comply with all
U.S. and International safety codes and regulations required for safe operation and use of commercial
equipment. Use standard and accepted safety practices with respect to operating commercial electrical
equipment at all times to avoid the risk of personal injury or death.
EMI/EMC The RC100C-2 SEGR complies with all FCC and CE regulations regarding electromagnetic
interference and compatibility. There are no personnel hazards or safety issues with respect to EMI/EMC
when operating the systems.
Exposures to Radio Frequency (RF) Signals The RC100C-2 SEGR is designed to receive RF signals
from 70 MHz to 5250 MHz at levels of +10 dBm to threshold. These signal levels are well below the
minimum safe exposure levels prescribed by both U.S. and International standards.

Table of Contents