Cirklon Sequencer User Manual
The GANG + ROW function can select all the notes in the current bar, or for the entire length
of the pattern. The scope for selection is shown at the top of the display while the GANG key
is held, and can be changed using the VALUE encoder.
The current setting (bar or pattern) is highlighted on the display while GANG is held.
Clearing the Ganged Selection
When the gang function is active, pressing and releasing the GANG key alone will turn off
gang mode. However, by default the notes will retain their ganged marker.
You can re-enter gang mode by pressing GANG again, and the previously ganged notes will
already be selected.
If you wish to clear all ganged note selections, hold the GANG key and press DELETE.
This will un-mark all notes in the pattern, and exit GANG mode.
Depending on your typical use of the gang function, you may find that you always want to
have the gang selection cleared when you exit gang mode.
This can be enabled with the user config option, “ck edit, auto clear gang”, described in the play
mode menu section.
To Next Page
Loading...
