Cirklon Sequencer User Manual
To re-load a previous dump, press encoder 9, “sysex recv”.
Then start transmission of the dump at the source device.
All being well, the previously saved data should re-load.
Factory Reset / Memory Initialisation
If you need to completely re-initialise Cirklon’s memory, you can do this as follows.
With the power off, hold down the SONG key.
Turn the power on, continuing to hold down the SONG key until you see the confirmation
page with the text “Wiping ALL data”
At this page, press encoders 6 and 8 together to confirm the full reset.
All song and instrument data will be removed, and all configuration settings returned to
default values.
To Next Page
Loading...
