Cirklon Sequencer User Manual
Set Step Value Events
The “Set Step Value” event group mainly has events to set a pattern value on the step to a
new value.
This may not seem like much use but it is very useful in combination with one of the mask
events.
For example, you might use it to randomly switch a step between two specified notes, or by
using the aux D accumulator and a mask event, you can perform pattern 'morphs', where the
notes of the pattern gradually switch from the normal note values to those set in a 'set note'
aux.
The events of this type are:
set note
set velocity
set length
set delay
xpose by n adds a set value to the note value
add n to xC adds a set value to the aux C value
add n to xD adds a set value to the aux D value
This group also contains:
set midi chan
…this allows you to re-assign a single step to any MIDI channel of your choice.
Great fun when used with another event to randomize the MIDI channel value!
Repeat Events
The “Repeat” event group used to create repeats of notes within the same step.
They are useful where you may want the occasional double speed note without having to use
a faster tbase setting, or for those 'Berlin School' grace note effects.
The first repeat note events all divide the step into equal parts for the main note and the
repeat notes.
So, a rep*2 will divide the step in two equal parts, and each note will play for a proportion of
their half of the step based on the length value for that step. rep*3 will divide the step in
three equal parts, and rep*4 into four.
To Next Page
Loading...
