Cirklon Sequencer User Manual
Redirect Aux Events
The “Redirect Aux” event group allow you to temporarily re-assign aux B, C or D to a
different MIDI controller or aux event.
There is no such event for aux A as the auxes are processed in order - you must re-direct one
aux from an earlier one. Since A is the first aux, it could not be re-directed.
aux B = cc #n temporarily re-assign aux B to a MIDI controller range: 0 - 127
aux B = event n temporarily re-assign aux B to an aux event range: aux events
aux C = cc #n temporarily re-assign aux C to a MIDI controller range: 0 - 127
aux C = event n temporarily re-assign aux C to an aux event range: aux events
aux D = cc #n temporarily re-assign aux D to a MIDI controller range: 0 - 127
aux D = event n temporarily re-assign aux D to an aux event range: aux events
auxes to trk n…
This event re-directs all following auxes so that they apply to the specified target track
instead of the current track.
This allows you to cascade more than four aux events to one track, or send more than the
maximum four MIDI CCs.
Pattern Control
This event group allows you to modify pattern settings.
set lstep abs sets the last pattern step range: 1 - 16
set lstep rel adds a given value to the last step range: +/- 15
set norm tbase set tbase to one of the standard settings (1, 2, 4, 8, 16, 32, 64)
set trplt tbase set tbase to one of the triplet settings (2T, 4T, 8T, 16T, 32T, 64T)
set direction set direction (always reset to stored value at the end of the pattern)
Global Control
This group allows you to modify global settings.
mute trk n deactivate track n range: 1 - 32
un-mute trk n activate track n range: 1 - 32
set tempo sets the global tempo, temporarily over-riding the tempo knob
To Next Page
Loading...
