Sequentix CIRKLON - Accumulator Mask Events

Sequentix Music Systems
Cirklon Sequencer User Manual
13-24
Accumulator Mask Events
The “Accumulator Mask” event group use the value of the aux D accumulator as a threshold
to control variations to a pattern:
Mask gate,dAcc>n defeat gate bit unless xD accumulator > value range: 0 - 127
Mask gate,n>dAcc defeat gate bit unless value > xD accumulator range: 0 - 127
Mask tie, dAcc>n defeat tie bit unless xD accumulator > value range: 0 - 127
Mask tie, n>dAcc defeat tie bit unless value > xD accumulator range: 0 - 127
Mask xB, dAcc>n defeat aux B unless xD accumulator > value range: 0 - 127
Mask xB, n>dAcc defeat aux B unless value > xD accumulator range: 0 - 127
Mask xC, dAcc>n defeat aux C unless xD accumulator > value range: 0 - 127
Mask xC, n>dAcc defeat aux C unless value > xD accumulator range: 0 - 127
mute trk, dAcc>n deactivate track when xD accumulator > value, and reset accumulator to
0
These events are used along with an “offset aux D rel” event.
For example, if you set up an offset event such that aux D increases by 1 each time the pattern
loops, you can set certain steps not to be activated until the pattern has played for up to 127
times.
This allows for very gradual modification of a pattern as it plays.
Knob Mask Events
The events in the “Knob Mask” group use the current position of the front panel knobs A
and B, or the track control values, knob1 and knob2, to control masking of gate, tie, the aux
statuses and accumulator defeats.
Refer to the chapter on track values for an explanation of how to assign and edit the knob1
and knob2 values for each track.
The knob source for each event is selected at the same time as you assign the event to an aux.
For each status value that can be masked, there are three events.
The first de-activates the status unless the knob value is greater than the aux value.
The second de-activates the status unless the knob value is within plus or minus 3 of the aux
value.
The third de-activates the status unless the knob value is less than the aux value.
The knob controlled mask events are: