Sequentix CIRKLON - Using more than 16 Tracks

Sequentix Music Systems
Cirklon Sequencer User Manual
2-3
Note: Where they are used on the SONG, SCENE or TRACK pages, the 16 keys and encoders
will be referred to as the track keys/encoders, since they each control one of 16 tracks.
In pattern edit, they will be referred to as the step keys/encoders, since they edit the step
values of the pattern.
The edit track selection can be changed on the SONG, SCENE or TRACK pages by pressing
the track encoders, or by turning the BAR encoder.
Using more than 16 tracks
The total number of tracks available is user-configurable to 16, 32, 48, or 64.
To change the number of tracks, see section 6 – Play Mode Menu, User Configuration.
Since there are only 16 track keys and encoders, if the number of tracks is set to 32 or more,
the tracks are mapped to the track keys and encoders in banks of 16.
You can step through the banks by pressing the BAR encoder.
A message on the display will show which tracks are selected.
Note that this may result in the edit track selection being outside the current track bank
selection, in which case none of the track encoder LEDs will be lit.
You may also change bank along with the edit track selection by turning the BAR encoder.
The single green track encoder LED will scroll across the tracks, and continue into the next
bank as you go past the end.