Cirklon Sequencer User Manual
This option will also reset some internal state information that is used to minimise the use of
MIDI bandwidth.
For example, if the same MIDI CC value is sent repeatedly by a pattern to a MIDI output, the
CC message is sent only once. There is usually no point sending the same value that has just
been sent.
However, after MIDI reset is pressed, the most-recently-sent state is cleared, so any
unchanging values will be re-transmitted.
This can be of use where a stored program change message has been sent to an instrument
which has then been manually changed to a different patch.
The stored program change message will be re-sent after a MIDI reset is performed.
Card / Sysex
This option gives access to the data saving and loading features, which are described in the
later section, “Loading and Saving Data”.
More…
Some less commonly used functions are to be found on the “more>” sub-menu.
Pressing this option brings up a further selection list:
Use the VALUE encoder to select from these options.
“import instrs” allows you to copy the instrument assignments from any other song in
memory.
The MIDI port config, MIDI options, CVIO Config and drum trig config pages will be
described in detail in the following sections.
To Next Page
Loading...
