Sequentix CIRKLON - Editing Pattern Values

Sequentix Music Systems
Cirklon Sequencer User Manual
3-3
The purpose and range of each of the row values is as follows:
row
purpose
range
note
Sets the MIDI note to be played
C0 to G#10
(MIDI notes 0 to 127)
velo
Sets the velocity value for the note message
1 to 127
length
Sets the duration of the note.
value is shown in the form s:tt
s shows a whole number of steps, tt shows
48
th
divisions of a step
0 ticks to 16 steps, or “hold”
delay
Allows the note start to be delayed by a
number of clock ticks (at 192 ppqn)
0 to 47
aux A – aux D
value
Set the values for assigned MIDI controller
messages, or aux events
MIDI CCs : 0 to 127
Aux event ranges vary
aux A – aux D
status
Trigger the associated CC or event
on / off
gate
Trigger the note
on /off
tie
Force the current note to sustain until just
after the start of the next step
on /off
skip
Skip over this step to the next un-skipped
step
on / off
Note that the length value can be longer than a single step period.
Assuming that the tie flag is not active, a note will continue to play for its full length,
overlapping any other notes in following steps.
This means the P3 pattern type can play overlapping, sustaining notes – a feature not
available on the P3 itself.
If the same note is triggered again while still playing, it will be released then re-triggered with
the new step length.
Editing Pattern Values
In pattern edit the 16 step encoders are used to change the numeric values.
The 16 step keys are used to toggle the flag values on and off.
The LEDs in the step keys indicate the current flag status.
In a newly created pattern, the step keys will be assigned to the gate flags, and the encoders to
the note values.
Turn on some of the steps by pressing the step keys.
Then press the RUN key to start Cirklon running.