Cirklon Sequencer User Manual
The menu options “set loop start” and “set loop end” allow you to set a smaller section of the
song to loop.
First select the scene you wish to start or end the loop with in the list.
Then press MENU, and select one of the “set loop …” options.
The labels “loop…” and “…end” beside the reps counts will show the loop points.
The “clear loop” option removes both loop settings from the song.
Recall / Copy To Workscene
These two options allow you to return to the workscene, to continue building a song.
If you switched to song play mode while you are working on a scene that you hadn’t saved,
“Recall workscene” will restore the workscene so you can continue to edit or save it.
“Copy to workscene” copies all the pattern assignments and values for the current scene into
the workscene and switches to it.
This allows you to return to the building phase of a song, incrementally saving variations on
the workscene as new scenes at the end of the scene list, without having to use save-as and
manually naming each scene.
Deleting A Scene
You can delete the currently selected scene in the list by pressing the DELETE key.
A confirmation screen will follow.
Note that only the scene itself is deleted.
Any patterns assigned in the scene will remain in memory, whether they are used in other
scenes or not.
To Next Page
Loading...
