Cirklon Sequencer User Manual
With the timebase of pattern B set to 1, pattern B will only play 1 step in the same time it takes
for pattern A to play all 16.
But the note value from pattern B that is used to transpose pattern A remains current for as
long as it takes the next step to play.
The result is pattern A will play for its whole length, transposed by the note value on step 1
of pattern B.
Then pattern A will play for a second time, transposed by the note value on step 2 of pattern
B.
And this will continue for all 16 steps of pattern B - giving you a means to sequence 16
repeats of pattern A, each one with a different transposition.
Plus B
The “xpose by trk n+B” event is much the same as “xpose by trk n”.
The “+B” is there because the note value used from the target track is taken after any bar
transpose is applied.
To Next Page
Loading...
