Cirklon Sequencer User Manual
To enable gang mode for the first time, hold down the GANG key, then press some of the
step encoders in turn, though don’t hold more than one track encoder together – that has a
different effect.
As you press each encoder, the LED below it should light green.
This shows the step has joined the gang.
After selecting a number of steps this way, release the GANG key.
The LED in the GANG key should remain lit, as will the green encoder LEDs for the ganged
steps.
Now edit the value on any of the ganged steps using its encoder.
The values of all the ganged steps will change by the same relative amount.
The effect is easiest to see in the row view.
Note that gang only applies to numeric values – not to the on/off flag values on the step keys.
Any steps which are not ganged can be still be edited as normal, without affecting any other
steps.
To turn off gang mode, press the GANG key again.
The GANG LED will go off, as will the green step encoder LEDs, restoring the single red LED
on the current step.
There are various ways to change the gang selection:
- to toggle steps in and out of the gang, hold GANG while pressing the step encoders
- to remove all the steps from the gang, hold the DELETE key and press GANG
- to invert the gang, i.e. to toggle the gang state of every step, hold SHIFT and press
GANG
A further option allows you to quickly gang a repeating pattern of steps.
If you hold the GANG key, then hold one step encoder and press another step encoder so
both encoders are held at the same time, those two steps will be added to the gang, along
with all the other steps in the bar at multiples of the spacing between the two selected.
For example, to gang every even numbered step:
- hold GANG
- hold step encoder 16
- press step encoder 14
Steps 14 and 16 will be ganged.
The gap between steps 14 and 16 is 2 steps, so every other step a multiple of 2 steps from
steps 14 and 16 will also be ganged.
In this case, that means every even step.
To Next Page
Loading...
