Cirklon Sequencer User Manual
The scene length (or bars remaining count for the current scene) is shown after the name, with
the letter ‘m’ to indicate a scene set for manual advance.
The first scene in any scene loop has a letter ‘S’, and the last scene in a loop a letter ‘E’.
A ‘>’ symbol appears between the step key number and the name of the current scene.
Any scene shown on the display can be selected directly by pressing the step encoder
mapped to it.
Unlike the scene list view, selecting a new scene here will not return you to the main scene
page.
While a change to another scene is pending, an asterisk (‘*’) will appear before that scene’s
name.
You can also scroll the highlight selection through the scenes using VALUE, and select the
next scene by pressing ENTER.
If there are more than 16 scenes in a song, the VALUE encoder can be used to move back and
forth through all the scenes. As you do so, a different bank of scenes will be mapped to the
step encoders for direct selection.
A scene loop can be set quickly here by holding one step encoder, then pressing and releasing
the encoder for a later scene.
The first scene selected will be queued as the next scene to play, and also set as the scene loop
start. The later scene will be set as the scene loop end.
This mode may be preferable to the basic scene list for improvising the structure of a song in
real-time, rather than sticking to a pre-determined scene order.
To Next Page
Loading...
