Function Manual
01/2017
85
Boundary conditions
(must be satisfied before the
command)
3 MD20112 START_MODE_MASK Initialization sequence with
4 /_N_CMA_DIR/CYCPE1MA.SPF and
as a subroutine Implied call of the path name as
5 None Processing of the data part of the
6 None
Processing of the program part of
the main program
For the sequence at part program end, see the table below:
Boundary conditions
(must be satisfied before the
command)
1 Channel selection: Reset status
Operating mode selection: AUTO or
AUTO and overstoring or
None Select channel and mode
Block with end of part program
3 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
Control activated:
Reset sequence with evaluation
4 /_N_CMA_DIR/CYCPE1MA.SPF and
as an ASUP Implied call of the path name as
5 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
Control activated:
Reset sequence with evaluation
The G code reset position con-
tinues to be specified with ma-
Event
Operator panel reset
For the processing sequence in operator panel reset, see the table below:
Boundary conditions
(must be satisfied before the
command)
1 Selection of channel and mode:
any
Initial state: Any mode, any
channel status
Select mode / channel status
from
3 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
Control activated:
Reset sequence with evaluation
4 /_N_CMA_DIR/CYCPE1MA.SPF and
as an ASUP Implied call of the path name as
5 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
Control activated:
Reset sequence with evaluation
The G code reset position con-
tinues to be specified with ma-
To Next Page
Loading...
