W1: Tool offset
18.15 Examples
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
1607
The compensation of the tool length is to be 1 mm in each axis (N80 to N100).
1 mm is thus added to the original length in lengths L2 and L3.
Twice the compensation value (2 mm) is added to the original tool length in L1, in order to change the total length
by 1 mm as required. If the positions approached in blocks N110 and N130 are compared, it can be seen that
each axis position has changed by 1 mm.
N150 r4 = $TC_DP4[1,1] ; = 5. = (4.000 + 1.000)
N160 r5 = $TC_DP5[1.1] ; = 6. = (5.000 + 1.000)
N170 m30
To Next Page
Loading...
