Siemens SINUMERIK 828D

P1: Transverse axes
12.3 Dimensional information for transverse axes
Basic Functions
832 Function Manual, 09/2011, 6FC5397-0BP40-2BA0
DIAMON/DIAMONA[AX]
• Display data of transverse axis in the workpiece coordinate system:
- Setpoint and actual position
- Distance-to-go
- REPOS Offset
• "JOG" mode:
- Increments for incremental dimension (INC) and handwheel travel (dependent upon active MD)
• Part program programming:
- End positions, independent of reference mode (G90 / G91)
- Interpolation parameters of circular-path programming (G2 / G3) if these are programmed with part
program instruction: AC absolute.
• Actual values read with reference to the workpiece coordinate system (WCS):
- $AA_MW[
Transverse axis ]
System variable of the measuring functions MEAS (measuring with delete distance-to-go) and MEAW
(measuring without delete distance-to-go)
- $P_EP[
Transverse axis ]
- $AA_IW[
Transverse axis ]
DIAM90/DIAM90A[AX]
After activation of the reference-mode-dependent diameter programming, the following data are always
displayed in relation to diameter regardless of the operating mode (G90 / G91):
• Actual value
• Actual values read with reference to the workpiece coordinate system (WCS):
- $AA_MW[
Transverse axis ]
System variable of the measuring functions MEAS (measuring with delete distance-to-go) and MEAW
(measuring without delete distance-to-go)
- $P_EP[
Transverse axis ]
- $AA_IW[
Transverse axis ]
DIAMCYCOF/DIACYCOFA[AX]
Just as for DIAMCYCOF, a changeover to radius programing takes place within the controller for
DIACYCOFA[AX]. The diameter programming status that was active before DIAMCYCOF or DIACYCOFA[AX]
continues to be displayed to the HMI.