© Siemens, 2008 SPR2-230.840.01.01.02 SIREMOBIL Iso-C
08.08 CS PS SP
Prerequisites 11
Page 11 of 148
For internal use only
Safety information 1.4
WARNING
Danger of possibly fatal physical injury and property dam-
age!
Noncompliance can lead to death, physical injury or property
damage.
¹ Follow the product-specific safety information in these
instructions,
¹ Follow the general safety information in the instruc-
tions TD00-000.860.01... and
¹ Follow the general safety information according to
ARTD Part 2.
WARNING
Electrical voltage!
Noncompliance can lead to death, physical injury or property
damage.
¹ Removing the system covers exposes voltage-con-
ducting parts. To avoid danger, always disconnect the
system from the line voltage before removing the cov-
ers. To do this, pull the power plug or switch the sys-
tem power supply off and secure the power switch
against accidental activation.
¹ If an uninterruptible power supply (UPS) is installed in
the system, the power supply of the UPS must addi-
tionally be switched free of voltage or the voltage out-
put plug must be unplugged.
¹ If service in connection with electrical voltage is
required, the general safety information in instructions
TD00-000.860.01... must be followed.
WARNING
Electrical voltage!
Noncompliance can lead to death, physical injury or property
damage.
¹ After service is performed on the primary circuit of the
ON/OFF assembly (e.g. replacement of the ON/OFF
assembly or any of its components), the device leak-
age current must be measured and recorded (see sys-
tem manual or logbook).
To Next Page
Loading...
