Siemens SIREMOBIL Iso-C

24 Prerequisites
SIREMOBIL Iso-C SPR2-230.840.01.01.02 © Siemens, 2008
08.08 CS PS SP
Page 24 of 148
For internal use only
x Install the cover and tighten the screws.
Installing/removing the cover at the C-arm mounting 0
x Remove the cover screws and remove both covers from the side.
x After completing the procedure, reinstall both covers in the reverse order.
Telescoping cover underneath the horizontal carriage 0
x Remove the four lower screws.
x Slightly loosen the two front screws and remove the telescoping cover from the bottom.