Siemens SIREMOBIL Iso-C

32 Loading the operating software
SIREMOBIL Iso-C SPR2-230.840.01.01.02 © Siemens, 2008
08.08 CS PS SP
Page 32 of 148
For internal use only
4- 4Loading the operating software
Control board D1, host 0
x Connect the service PC to the serial service interface on SIREMOBIL Iso-C.
x Start the service program.
x Insert the "Parameter" diskette into drive A.
x Select the Download menu and start the download (ARC / Fil / Host).
x After successfully downloading, wait for the system to boot (1 minute).
x The SIREMOBIL Iso-C is operational.
NOTE
If you cannot run download (e.g. power failure during down-
load):
Switch the SIREMOBIL Iso-C off and back on.
Restart download.