© Siemens, 2008 SPR2-230.840.01.01.02 SIREMOBIL Iso-C
08.08 CS PS SP
Replacing boards and components 123
Page 123 of 148
For internal use only
3D reconstruction PC 6.23
Fig. 38:
NOTE
Only applies to SIREMOBIL Iso-C 3D.
x Disconnect the system from the power supply by pulling the line power plug plug out of
the socket.
x The syngo software and the backup/restore disk are kept in the monitor trolley logbook.
x Unplug all connectors on the PC.
x Unscrew the dongle from the printer port of the PC and reinstall it on the new PC (see
(Fig. 38 / p. 123)).
x Replace the PC.
x Reconnect all connectors.
x Perform the startup of the 3D reconstruction PC as described in the Startup Instruc-
tions, Chapter 4.
x Then insert the backup / restore disk (in the logbook compartment of the SIREMOBIL
Iso-C) into the disk drive of the PC.
x Start the syngo service software.
x Select the Backup / Restore menu and restore the data.
x Perform a function check of the PC.
x Perform the IQ quick test.
x Check the DICOM functionality of the PC, if applicable.
To Next Page
Loading...
