Siemens SIREMOBIL Iso-C

© Siemens, 2008 SPR2-230.840.01.01.02 SIREMOBIL Iso-C
08.08 CS PS SP
Replacing boards and components 133
Page 133 of 148
For internal use only
x Retighten the Allen screw of the large pulley.
x Perform the mechanical settings as described in the Startup Instructions, Chapter 6.
To avoid damage to the new Orbital Pot when replacing, just do this:
Put new pot in but do not tighten the grub screw. Go into main
system<>Potiadjust and move the pot to give a reading of 200 when C
Bow it set at 95', then tighten grub screw..