Simplex 4005 Programming Instructions

vii
Input Field 3 and Input Field 4....................................................................3-11
Overview................................................................................................. 3-11
Using the FIRE Qualifier........................................................................3-11
Using the FIRE DET Qualifier ...............................................................3-12
Using the FIRE ACK Qualifier............................................................... 3-13
Using the SUPV Qualifier.......................................................................3-13
Using the SUPV ACK Qualifier ............................................................. 3-14
Using the TBL Qualifier ......................................................................... 3-14
Using the TBL ACK Qualifier................................................................3-15
Using the ON/CODE and OFF Qualifiers...............................................3-15
Second Stage Fields....................................................................................3-17
The COMP CNST, ANY, ALL, and DELAY CNST Qualifiers.............3-17
Using the COMP CNST Qualifier .......................................................... 3-17
Using the ANY Qualifier ........................................................................3-18
Using the ALL Qualifier.........................................................................3-18
Using the DELAY CNST Qualifier ........................................................3-19
Output Statements.......................................................................................3-20
Output Side (THEN)............................................................................... 3-20
Output Field 1......................................................................................... 3-20
Output Field 2......................................................................................... 3-20
Output Field 3......................................................................................... 3-21
Chapter 4. Common Simplex Multi-Functional
Programming Language (SMPL) Applications
Introduction...............................................................................................4-1
Selective Signals by Floor......................................................................... 4-1
Selective Signals by Zone.........................................................................4-3
Selective Signal Operation for Fire Floor, Floor Above,
and Floor Below........................................................................................4-4
Selective Relay Control for Fan/Damper Operation .................................4-5
Selective Bypass of NAC/Relay Circuits..................................................4-8
Pre-Signal Operation................................................................................. 4-9
Cross-Zoning Function............................................................................4-10
Non-Latching / Non-Alarm Point Operation...........................................4-10
AC Power Failure Operation................................................................... 4-11
Delay Door Drop on AC Power Failure Operation.................................4-11
SCU/RCU Point Matrix (Zone Grouping) ..............................................4-12
Stagger/Start Operation...........................................................................4-13
Elevator Recall Operation.......................................................................4-14
Chapter 5. Point Type Charts
Introduction...............................................................................................5-1
Displaying information on the LCD Panel................................................5-1
Point Type Messages for Monitor Points...................................................... 5-3
Monitor Points ..........................................................................................5-3
Point Type Messages for Signal Points.......................................................5-13
Signal Points ........................................................................................... 5-13
Technical Manuals Online! - http://www.tech-man.com

Simplex 4005 Specifications

General

Brand	Simplex
Power Supply	24 VDC
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
Compatibility	Compatible with Simplex fire alarm control panels