Simplex 4005 - Disabling;Enabling Points

2-25
The Cut-Out Timer is a specified time (0-60 mins.) for signals to sound until
they automatically turn off. To set the Cut-Out Timer in minutes for the 4005,
use the following steps:
1. Follow Steps 1 through 3 under Editing a Point Label.
2. Press <Next> or <Previous> to scroll through the menus until
[
6\VWHP2SWLRQV] is displayed (A) and then press <Enter>.
A.
B.
C.
D.
Figure 2-23. Typical Screens Used to Set the
Cut-Out Timer
3. Press <Next> or <Previous> until [
&XW2XW7LPHU] is displayed (B) and
then press <Enter>.
The focus brackets ( [ ] ) appear in the New: field (C) of the display.
4. Press <Next> or <Previous> to choose the duration (1-60 minutes) for the
signal cut-out timer and then press <Enter>.
Note: When initially setting a value for a System Option, all values in the
‘New:’ field reflect the ‘Current:’ field’s setting. A value of 00 is
considered a disabled state of that System Option (for example,
00 Mins means that the Cut-Out Timer is not active).
5. Press <Enter> to confirm your selection or Exit to cancel (D).
“Option is updated” is displayed when selecting Enter.
Cut-Out Timer
Setting the Cut-Out Timer
),5(  683(59,625< 7528%/( 
3URJUDPPLQJ>6\VWHP2SWLRQV@
),5(  683(59,625< 7528%/( 
6\VWHP2SWLRQV>&XW2XW7LPHU@
6LJQDO&XW2XW7LPHU
1HZ>@  &XUUHQW0LQV
3UHVV(17(5WRFRQILUP(;,7WRFDQFHO
1HZ>@  &XUUHQW0LQV
Technical Manuals Online! - http://www.tech-man.com