2-13
You can change the mode of a Generic Output point. (If another type of point is
chosen, you are notified that this is an invalid action.)
Mode editing of a point associated with the output of a SMPL equation is not
allowed.
Note: The following describes assigning Links between an LED of a
RCU card to a Fire monitor point (18-01).
To Edit the Mode of a point, use the following steps:
1. Follow Steps 1 through 5 under Editing a Point Label.
2.
P
ress <Ne
xt> or <P
revious>
to scro
ll through the p
oints until the po
int
you wish to edit is displayed (A) and then press <Function>.
3.
P
ress <Ne
xt> or <P
revio
us> to scro
ll through the menus until
[
(GLW0RGH] is displayed (B) and then press <Enter>.
4.
P
ress <Next>
or <P
revious> to
scroll thr
ough the actio
ns until the desir
ed
action is displayed then use the <ö> to move the focus brackets ([ ]) to
the point you wish to link to a RCU/SCU point. Use <Next> or
<Previous> to scroll through the points until the desired point is displayed
(C) and then press <Enter> (see the Table 2-3 for your choices of Output
Modes and Link to… options).
5. A Confirmation screen appears (D) allowing you to make or abandon the
changes. Press <Enter> to confirm your choice, or <Exit/Clear> to
abandon your changes.
A.
B.
C.
D.
Figure 2-12. Typical Screens Used in Edit Mode Programming
Continued on next page
Edit Mode Programming
Edit Mode Programming
5&8&DUG/('
/('
5&8&DUG/('
&RQWURO>(GLW0RGH@
0RGH3URJUDPPLQJ²*HQHULF2XWSXW
)LUH >@
3UHVV(17(5WR&RQILUP(;,7WR&DQFHO
>)LUH@ ²
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
