2-34
The Restore CFIG option allows you to abandon all changes to the 4005 edit
buffer. There are two ways to abandon your changes to the 4005’s edit buffer:
• At the end of an edit session
• Anytime during programming
To abandon changes at the end of an editing session, use the following steps:
1. Press and hold <Exit/Clear> after all your changes to the 4005
programming are made (A).
A.
B.
C.
Figure 2-32. Typical Screens Used to Abandon
Changes at the End of an Editing Session
2. Press <ö> or <ì> to choose [
5HVWRUH&),*] (B).
3. Press <Enter> (C).
4. Press <Enter> to confirm your selection or <Exit/Clear> to cancel.
The 4005 clears the edit buffer information. You can now start a new edit
session.
Continued on next page
Canceling Editing Changes
Overview
Abandoning Changes at the
End of an Editing Session
(GLW%XIIHUKDV&+$1*('
>&DQFHO@5HVWRUH&),*6DYH&),*
(GLW%XIIHUKDV&+$1*('
&DQFHO>5HVWRUH&),*@6DYH&),*
5HVWRULQJ&),*
3UHVV(17(5WR5HVWRUH(;,7WR&DQFHO
Technical Manuals Online! - http://www.tech-man.com