2-18
To modify an Input/Output Card of the 4005, use the following steps:
1. Follow Steps 1 through 3 under Editing a Point Label.
2.
P
ress <Ne
xt> or <P
revio
us> to scro
ll through the menus until
[
(GLW&DUG] is displayed (A) and then press <Enter>.
A.
B.
C.
Figure 2-16. Typical Screens Used to Modify
Input/Output Card Devices
3.
Press <Next> or <P
revious> until [
0RGLI\,2&DUG'HYLFHV] is displayed (B) and then press <Enter>.
The focus brackets ( [ ] ) appear in the Card Address field (C) of the
display.
4.
Press <Nex
t> or <Previou
s> to choose t
he Card to m
odify an
d then pres
s
<Enter>.
5. Press <Function> to modify the card.
Certain Functions are allowed during the Modify I/O Card Devices session.
By pressing the <Function> key, the device type edit screen is displayed
(D).
D.
Figure 2-17. Device Type Edit Screen
For an input device type, the points are always MON (MONA or MONB
is implied by the selected card type). If all four points are MONA or
MONB, then no editable points exist. For an output device type, you can
select: SIG (which is either SIGA or SIGB depending on the selected
card), or AUX.
In the case of the 2-Input / 2-Output cards, you can only edit the output
points (i.e., points 3 and 4) of the card.
Continued on next page
Modifying Input/Output Card Devices
Modifying Input/Output Card
Devices
),5( 683(59,625< 7528%/(
3URJUDPPLQJ>(GLW&DUG@
),5( 683(59,625< 7528%/(
(GLW&DUG>0RGLI\,2&DUG'HYLFHV@
&DUG >@3DQHO6ORW
&DUG7\SH 3RLQW1$&5HOD\
&DUG 3RLQW1$&5HOD\
&WO >6LJ@&W 6LJ&W $X[&W $X[
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
