Simplex 4005 Programming Instructions

2-32
There are two ways to save the edit buffer information to the 4005’s CFIG:
• At the end of an edit session
• Anytime during programming
To save changes at the end of an editing session, use the following steps:
1. Press and hold <Exit/Clear> after all your changes to the 4005
programming are made (A).
A.
B.
C.
Figure 2-30. Typical Screens Used to Save Changes
at the End of an Editing Session
2. Press <ö> or <ì> to choose [
6DYH&),*] (B).
3. Press <Enter> (C).
4. Press <Enter> to confirm your selection or <Exit/Clear> to cancel.
The 4005 downloads the edit buffer information to the 4005 program.
When the download completes, the 4005 performs a cold start.
Continued on next page
Saving Editing Changes
Overview
Saving Changes at the End of
an Editing Session
(GLW%XIIHUKDV&+$1*('
>&DQFHO@5HVWRUH&),*6DYH&),*
(GLW%XIIHUKDV&+$1*('
&DQFHO5HVWRUH&),*>6DYH&),*@
6DYLQJ&),*
3UHVV(17(5WRVDYH(;,7WR&DQFHO
Technical Manuals Online! - http://www.tech-man.com

Simplex 4005 Specifications

General

Brand	Simplex
Power Supply	24 VDC
Operating Temperature	32°F to 120°F (0°C to 49°C)
Humidity Range	Up to 93% RH, non-condensing
Compatibility	Compatible with Simplex fire alarm control panels