SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2018 74
1. In the left navigation bar, click Advanced Setup > Security and then click Add. The following page appears. You can also
reach this page by clicking Advanced Setup > Security > IP Filtering > Outgoing.
2. Fill in the fields, using the information in the table below.
3. Click Apply/Save to commit the completed entry.
The fields on this page are defined below.
Field Name Description
Filter Name Enter a descriptive name for this filter. No special characters or spaces are allowed.
IP Version For the filter to be configured and effective for IPV6, the gateway must be installed on a network that is
either a pure IPV6 network (with that protocol enabled) or is both IPV4 and IPV6 dual protocol enabled/-
configured. Options are IPv4 and IPv6. The default is IPv4.
If you select IPV6, Source IP address and Destination IP address must be specified in IPV6 format, i.e., an
IPV6-compliant, hexadecimal address such as: 2001:0DB8:AC10:FE01:0000:0000:0000:0001.
Protocol Select the protocol profile for the filter you are defining. TCP/UDP is most commonly used. Options are
TCP/UDP, TCP, UDP, and ICMP.
Source IP address
[/prefix length]
Enter the source IP address of a LAN side host for which you wish to block outgoing traffic using the spe-
cified protocol(s).
Note: The address specified here can be a particular address or a block of IP addresses on a given network
subnet. This is done by appending the associated routing "prefix" length decimal value (preceded with the
slash) to the addresses.
Source Port (port Set the source host port (or range of ports) for the above host (or range of hosts) to define the ports profile
To Next Page
Loading...
