SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2018 134
Field Name Description
OAM ID Enter the ID of this OAM configuration. Only positive numbers are allowed.
Auto Event Click to enable automatic reporting of events.
Variable Retrieval Click to enable on-demand link diagnostics, including bit-error-rate approximation.
Link Events Click to enable reporting of critical conditions that may cause link failure.
Remote Loopback Click to enable on-demand link diagnostics, including bit-error-rate approximation.
Active Mode Click to enable this feature.
Ethernet Service OAM (802.1ag/Y.1731) section
WAN Interface Select the WAN interface that you want to test.
MD Level (Appears for the 802.1ag option only) Select the domain level for this maintenance domain. Options are
0 - 7. The larger the domain, the higher the value you should select.
MD Name (Appears for the 802.1ag option only) Enter the name of the maintenance domain, e.g., Broadcom.
MA ID (Appears for the 802.1ag option only) Enter the maintenance association ID, e.g., BRCM.
MEGLevel (Appears for the Y.1731 option only) Enter the level of the maintenance entity group.
MEG ID (Appears for the Y.1731 option only) Enter the IDof the MEG.
Local MEP ID Enter the IDof the local maintenance entity group end point.. Options are 1 - 8191. The default is 1.
Local MEP VLAN ID Enter the VLAN ID of the local MEP. Options are 1 - 4094. The default is -1 (no VLAN tag).
CCM Transmission Click to enable continuity check message transmission.
Remote MEP ID Enter the IDof the remote MEP. Options are 1 - 8191. The default is -1 (no remote MEP).
Loopback and Linktrace Test section
Target MAC Enter the MAC address for the test, e.g., 02:10:18:aa:bb:cc.
Linktrace TTL Enter the maximum number of hops allowed. Optinons are 1- 233. The default is -1 (no limit).
Loopback Result Displays the results of the loopback test.
Linktrace Result Displays the results of the linktrace test.
Diagnostic Tools
In this section, you can ping or trace the communication route, and start or stop your DSL connection.
Ping
On this page you can ping a server by host name or IP address.
To Next Page
Loading...
