SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2018 113
Field Name Description
l Use AP PIN: The entry field and the Set Authorized Station MAC field disappear.
Note: If the PIN and Set Authorized Station MAC fields are left blank, the PBC (push-button) mode is
automatically made active.
Set Authorized
Station MAC
(Available only when Enter STA PIN is selected) Enter the MAC address of the authorized (input) sta-
tion in format: xx:xx:xx:xx:xx:xx.
Set WPS AP Mode Select how security is assigned to clients.
l Configured: The gateway assigns security settings to clients. This is the default.
l Unconfigured: An external client assigns security settings to the gateway.
Device PIN This value is generated by the access point.
3. In the Manual Setup AP section, select the SSID for the device that you want to configure. The default is the 5 GHz wire-
less band defined for your gateway.
4. Select the Network Authentication method and then fill in the fields that appear. The default method is Mixed WPA2 /
WPA-PSK. Detailed instructions are provided for each method in the following sections:
l Open and Shared Authentication
l 802.1X Authentication
l WPA2 and Mixed WPA2/WPA Authentication
l WPA2-PSK and Mixed WPA2/WPA-PSK Authentication
5. Click Apply/Save to commit your changes.
Open and Shared Authentication
The same configuration fields apply for both Shared and Open authentication types except that WEP Encryption is enabled by
default for the Shared method.
The following fields appear when you select Open or Shared in the Network Authentication field and WEP Encryption is
enabled.
To Next Page
Loading...
