SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2018 76
Field Name Description
Filter Name Enter a descriptive name for this filter. No special characters or spaces are allowed.
IP Version For the filter to be configured and effective for IPV6, the gateway must be installed on a network that
is either a pure IPV6 network (with that protocol enabled) or is both IPV4 and IPV6 dual protocol
enabled/configured. Options are IPv4 and IPv6. The default is IPv4.
If you select IPV6, Source IP address and Destination IP address must be specified in IPV6 format,
i.e., an IPV6-compliant, hexadecimal address such as: 2001:0DB8:AC10:FE01:0000:0000:0000:0001.
Protocol Select the protocol to be associated with this incoming filter. Options are TCP/UDP, TCP, UDP, or
ICMP.
Source IP address [/pre-
fix length]
Enter the source IP address for this filter. For IPv6, enter the prefix as well.
Source Port (port or
port:port)
Enter a source port number or range (xxxxx:yyyyy).
Destination IP address
[/prefix length]
Enter the destination IP address for this filter. For IPv6, enter the prefix as well.
Destination Port (port or
port:port)
Enter destination port number or range (xxxxx:yyyyy).
WAN Interfaces Click to apply this rule to all WAN interfaces or only certain types. Options are Select All or select
any of the types defined for your network. The default is Select All.
MAC Filtering
On this page, you can manage MAC filtering for your gateway.
Your gateway can block or forward packets based on the originating device. This MAC filtering feature is available only in Bridge
mode. For other modes, similar functionality is available via IP Filtering.
To Next Page
Loading...
