SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2018 111
Field Name Description
Enable WMF Click to enable Wireless Multicast Forwarding (WMF).
Enable HSPOT Click to enable Hotspot 2.0 access.
Max Clients Enter the maximum number of clients that can connect to this access point.
BSSID Displays the Basic Service Set Identifier or N/A.
Security
On this page, you can configure network security settings of a wireless LAN interface, either by using the WiFi Protected Setup
(WPS) method or by setting the network authentication mode. For WiFi Protected Setup, the following methods are supported:
l PIN entry: Mandatory method of setup for all WPS-certified devices. Options are:
l Enter STA PIN: You must enter the (input) station PIN from the client.
l Use AP PIN: The access point (AP) generates the device PIN.
l PBC (Push Button Configuration): Uses a simulated push button in the software. (This is an optional method on wireless
clients.)
Note: To use the PIN method, you need a Registrar (access point/wireless gateway) to initiate the registration between a new
device and an active access point/wireless gateway. The PBC method may also need a Registrar when used in a special case
where the PIN is all zeros.
Seven types of network authentication modes are supported: Open, Shared, 802.1X, WPA2, WPA2-PSK, Mixed WPA2/WPA, and
Mixed WPA2/WPA-PSK.
To Next Page
Loading...
