Sonifex S2 - Page 126

114
S2 User Handbook
16
To calibrate, hold down the PGM button and press the AUD button 5 times. The lock LED on
the front panel will ash quickly for 2 – 3 seconds and will return to it’s previous state. The
calibration procedure is now complete.
Button Mode Settings
To make the S2 modules as exible as possible, every button on each channel can be set
to a number of dierent modes. These will aid in the use of the mixer and allow for extra
functionality. To make use of these modes, you must enter a setup mode which is exactly
the same for every module. It is only necessary to perform this procedure once.
To enter the setup mode, hold down the PGM and AUD buttons together for 5 seconds.
After which all the buttons will start a recurring ashing sequence, at this point it is ok to
release the PGM and AUD buttons. This sequence indicates the mode which each button is
currently set to. One ash equals mode one, two ashes equals mode two etc. To change the
mode for a particular button simply press it once and watch the number of ashes increase.
Once the maximum mode number has been reached it will simply wrap around to mode
one and continue as before. To exit this setup procedure press and hold both the PGM and
AUD buttons as before for 2 seconds and the module will start operating as normal.
Each button and their corresponding modes are listed below.
PGM
Mode 1 : Normal. PGM can be selected as the meter feeder as normal.
Mode 2 : Always on. PGM is permanently selected as the meter feed.
Mode 3 : Always o. PGM can never be selected as the meter feed.
AUD
Mode 1 : Normal. AUD can be selected as the meter feeder as normal.
Mode 2 : Always on. AUD is permanently selected as the meter feed.
Mode 3 : Always o. AUD can never be selected as the meter feed.
CR MON
Mode 1 : Normal. The Control Room Monitor channel be selected as the meter feed as
normal.
Mode 2 : Always on. The Control Room Monitor channel is permanently selected as the
meter feed.
Mode 3 : Always o. The Control Room Monitor channel can never be selected as the
meter feed.
Note: If more than one button is set to mode 2 (Always on) then the meter feed will be
a mix of these sources. This may not be desirable in most applications.
S2ODAF/S2ODA DIGITAL OUTPUT AUD CHANNEL
WITH & WITHOUT MASTER FADER VERSION 1
S2ODAF/S2ODA DIGITAL OUTPUT
AUD CHANNEL WITH & WITHOUT
MASTER FADER VERSION 1