Sonifex S2 - Channel Options, Jumper Settings and Presets

S2 User Handbook
63
The connector pin-outs are as follows;
Pin 1: Opto isolated Line 1 start NPN collector.
Pin 2: Common NPN emitter for Line 1 start and stop.
Pin 3: Opto isolated Line 1 stop NPN collector.
Pin 4: Opto isolated Line 2 start NPN collector.
Pin 5: Common NPN emitter for Line 2 start and stop.
Pin 6: Opto isolated Line 2 stop NPN collector.
Pin 7: 0V logic.
Pin 8: General purpose I/O 1.
Pin 9: General purpose I/O 2.
Input 1 AES/EBU Connector
This XLR 3 pin socket is used for AES/EBU Input 1, and has the following connections;
Pin 1: Screen.
Pin 2: Phase.
Pin 3: Non-phase.
Input 2 AES/EBU Connector
This XLR 3 pin socket is used for AES/EBU Input 2, and has the following connections;
Pin 1: Screen.
Pin 2: Phase.
Pin 3: Non-phase.
Channel Options, Jumper Settings and Presets
The digital dual stereo channel with and without EQ can be congured in a number of
dierent ways depending on the jumper options set on the board. The on-board processor’s
software is congured by jumpers J1 to J5 and channel identifying links. The digital dual
stereo channel without EQ is identied by having links LK4 and LK12 tted. The digital dual
stereo channel with EQ is identied by having links LK5 and LK12 tted. Other, customer
specic, options can be programmed into the software by special order. Special logic
options will be identied by having links LK9 and LK10 tted.
The standard options available are;
t 4FMFDUNPNFOUBSZPSMBUDIFETUBSUGPS*OQVUSFNPUFPVUQVU
t 4FMFDUNPNFOUBSZPSMBUDIFETUBSUGPS*OQVUSFNPUFPVUQVU
t &OBCMFDPOUJOVPVTNPNFOUBSZTUBSUGSPN0/CVUUPO
t &OBCMFPSEJTBCMF$VF1'-DBODFMGSPNGBEFS
t 4FMFDUUJNFSPQUJPO
t 4FMFDU"&4&#6PS41%*'GPS*OQVU
t 4FMFDU"&4&#6PS41%*'GPS*OQVU
t #BM1BO$POUSPM4FUVQ
S2CDSE/S2CDS DIGITAL DUAL
STEREO LINE CHANNEL WITH &
WITHOUT EQ
9
S2CDSE/S2CDS DIGITAL DUAL STEREO LINE CHANNEL WITH & WITHOUT EQ