Sonifex S2 - Rear Panel; Configuring the Timer

S2 User Handbook
147
METERBRIDGE MODULES
METERBRIDGE MODULES
20
Quick Time View
Hold down the lower timer “START/STOP” button while in Date mode.
The Time will be displayed until the button is released.
Rear Panel
RS232 Connector
This 9 pin D type plug is used for connecting to another RS232 enabled device
(e.g PC’s Com port).
The connector pin-out is as follows;
Pin 1: CD.
Pin 2: Receive Data (From PC).
Pin 3: Transmit Data (To PC).
Pin 4: DTR.
Pin 5: Ground.
Pin 6: DSR.
Pin 7: RTS.
Pin 8: CTS.
Pin 9: No internal connection.
NOTE: Only Pins 2 & 3 are currently used.
MSF/DCF Antenna & SMPTE/EBU Connector
This 9 pin D type socket is used for receiving a time code signal from an MSF/DCF antenna
or other compatible sources.
The connector pin-out is as follows;
Pin 1: Signal+.
Pin 2: Signal-.
Pin 3: Ground.
Pin 4: +VD.
Pin 5: No internal connection.
Pin 6: Ground.
Pin 7: Ground.
Pin 8: 5V.
Pin 9: 5V.
+VD: Digital power rail. ~8.5V.
Conguring The Timer
The timers are congured according to the following comprehensive instructions,
Setting The Time
t )PMEEPXOUIFVQQFSUJNFS.PEFCVUUPOGPSTFDPOET
t 5IFVQQFSEJTQMBZXJMMOPXCFEJTQMBZJOHUIFEBUFXJUIUIFZFBSEJHJUTøBTIJOH