Sonifex S2 - Safety of Mains Operated Equipment

S2 User Handbook
5
Fig 2-2 : Mixer Cut-Out Details.
Channel Conguration
Each of the channels can be re-congured by jumpers, which are displayed in the “Channel
Options and Jumper Settings” section of each chapter. You should ensure that you are
thoroughly familiar with the settings available for each channel before attempting
installation of the mixer. This is because some options may involve moving jumpers on
several channels to change the conguration of the mixer.
Connectors and Cabling
Many of the problems associated with installing and maintaining a mixing console are due
to the use of poor cables or faulty connections. It is recommended that, wherever possible,
pre-wired cables are purchased from recommended manufacturers. If you need bespoke
cables making, please ensure that a qualied engineer carries out the work.
INSTALLATION NOTES
INSTALLATION NOTES
2
196mm S2-5
387mm S2-10
577mm S2-15
768mm S2-20
958mm S2-25
1149mm S2-30
Woodwork
Front Edge
506mm
40mm
276mm
Woodwork
Rear Edge