Sonifex S2 - Page 43

S2 User Handbook
31
Summary of Jumper Settings for the Mic/Line Channel With EQ
Jumper Set over Pins Eect
J1
1 & 2
None
Latching contact for Mic cue light.
Momentary contact for Mic cue light.
J2
1 & 2
None
Latching contact for Line remote start.
Momentary contact for Line remote start.
J3
1 & 2
None
Continuous momentary start from ON button,
see following description.
Normal start function.
J4
1 & 2
None
Fader up signal cancels previously selected Cue/PFL.
Normal Cue/PFL function.
J5
1 & 2
None
Microphone on Line input.
Normal Line input.
J6
1 & 2
2 & 3
Phantom power to Microphone.
Normal operation.
J7
1 & 2
None
Full LF response on Microphone input.
LF roll o.
J8 Not Fitted
J9 Not Fitted
J10
1 & 2
None
Insert point enabled (Insert in).
Insert out only.
J11 Not Fitted
J12 Not Fitted
J13
1 & 2
2 & 3
None
Control room monitor mute from Microphone input.
Studio monitor mute from Microphone input.
No mute function.
J14
1 & 2
2 & 3
None
Auto start Timer 1.
Auto start Timer 2.
No timer function.
J15
1 & 2
2 & 3
None
Control room monitor mute from Line input.
Studio monitor mute from Line input.
No mute function.
J16
1&2
2&3
None
MIC1 is selected as Talkback input
Reserved
No Talkback input
Note: Options in bold are set as default when shipped.
S2CML MIC/LINE CHANNEL WITH EQ
S2CML MIC/LINE CHANNEL WITH EQ
5