Chapter 20 Switcher Setup (Switcher)
1032
Signal Input Settings (Input Menu)
Setting the image position in edge crop up-conversion mode
1
In the <Edge Crop Position> group of the Switcher >Input >FC Adjust
menu, press [Position], turning it on.
2
Adjust the following parameter.
a) For down-conversion, the value is from –30 to +30 inclusive.
To return the edge crop image to the center
In the <Edge Crop Position> group, press [Center].
Setting the image position in letter box up-conversion mode
1
In the <Letter Box Position> group of the Switcher >Input >FC Adjust
menu, press [Position], turning it on.
Original image (4:3) Up-converted image (16:9)
Edge Crop
Letter Box
Squeeze
Knob Parameter Adjustment Setting format Setting values
2 EC Position Image position
a)
1080 –120 to +120
720 –80 to +80
To Next Page
Loading...
